In this video, we’ll explore the installation steps for hardwiring the GPSI-5000. Use the timestamps below to jump to specific sections of the video: Vehicle Preparation…………………………………………00:44 Device Harness Preparation………………………….01:54 Locating Power, Ignition, and Ground………….02:47 Connecting the Harness………………………………..04:39 Verifying and Securing the Installation……….05:21
Before You Begin The installation kit contains the GPSI-5000 GPS device, Diagnostic Cable, ring terminal, ground screw, star washer, 14-in and 8-in cable ties, installation guide and registration card. Additional tools that you may need include a pen, dash panel removers, insulated crimpers, wire cutters, wire strippers, electrical tape, tamper seal, cordless drill, Phillips bit,…
Before You Begin The installation kit contains the GPSI-5000 GPS device, 24-pin harness, ring terminal, ground screw, star washer, 14-in and 8-in cable ties, installation guide and registration card. Additional tools that you may need include a pen, dash panel removers, insulated crimpers, wire cutters, wire strippers, electrical tape, tamper seal, cordless drill, Phillips bit,…
Questions about our ELD option, ELD Complete? Check out the below. Frequently Asked Questions
The installation kit contains 4 in. (10 cm) heat shrink tubing, magnetic reed switch, magnet, sandpaper, four 8 in. (20.3 cm) cable ties, self-tapping screw, ring terminal, star washer, 8 ft. (2.5 m) extension cable, and glue. Additional tools you may need include a fine tip marker, end cutting nipper pliers, razor knife, heat gun,…