GPSI-5000 – FAQ
Questions about the GPSI-5000? Check out the below. GPSI-5000 Frequently Asked Questions
Questions about the GPSI-5000? Check out the below. GPSI-5000 Frequently Asked Questions
The installation kit contains two fobs, panic button receiver, light, two inline fuse holders, two fuses, 4 ft. (1.2 m.) extension cable, self-tapping screw, ring terminal, star washer, six butt connectors, eight 8 in. (20 cm.) cable ties, and two 14 in. (35.5 cm.) cable ties. Additional tools needed include a cordless drill, 1/2 in.…
The installation kit contains the temperature sensor, one p-clamp, two heat shrink butt connectors, two standard butt connectors, two grommets, eight 8 in. (20 cm) cable ties with screw hole, twelve 8 in. (20 cm) cable ties, nine self-tapping screws and 18 ft. cable extension. Additional tools and parts you will/may need are electrical tape,…
Typically when Input monitoring is ordered an Input Kit is also shipped containing a relay, relay harness, diode, wire, fuse holder and fuse. Additional tools and/or parts that you may need include: razor knife, electrical tape, zip ties, wire crimper, wire stripper, wire cutter, 12V or 24V relay, relay harness, 20ga wire, ground screw, ring…
The Driver ID kit contains one Reader, two key fobs, one plastic washer, one metal-locking washer, one wiretap connector, four butt connectors, four 8 in. (20 cm) cable ties, and one Light or Buzzer (optional). Additional tools and supplies you need include a cordless drill, one 3/8 in. (10 mm) drill bit, one 1/2 in.…