Unit Verification App

With the GPS Insight Unit Verification App (iOS | Android), you no longer have to call in to verify your installation. The application allows you to quickly verify the installation of the GPS device as well as register the device for immediate viewing within the portal. The screenshots within this guide are specific to the…

Add-On: GPSI-3900/4000 Garmin Traffic Cable

The installation kit contains the Garmin traffic cable, two 8 in. (3 cm) cable ties, ring terminal, star washer, and self-tapping screw. Additional tools you may need include a cordless drill, multimeter, Phillips bit, wire stripper, electrical tape, and insulated crimper. Installation Steps The following steps provide an overview of the installation process: Install preparation.…

Add-On: GPSI-3900/4000 Remote Panic

The installation kit contains two fobs, panic button receiver, light, two in-line fuse holders, two fuses, 4 ft. (1.2 m) extension cable, self-tapping screw, ring terminal, star washer, six butt connectors, eight 8 in. (20 cm) cable ties, and two 14 in. (35.5 cm) cable ties. Additional tools you may need include a multimeter, cordless…

Add-On: GPSI-3900/-4000 Seatbelt Monitor

The installation kit contains 4 in. (10 cm) heat shrink tubing, magnetic reed switch, magnet, sandpaper, four 8 in. (20.3 cm) cable ties, self-tapping screw, ring terminal, star washer, 8 ft. (2.5 m) extension cable, and glue. Additional tools you may need include a fine tip marker, end cutting nipper pliers, razor knife, heat gun,…

Add-On: GPSI-4000 Driver ID

The Driver ID kit contains one reader, two key fobs, one plastic washer, one metal-locking washer, one wiretap connector, four butt connectors, four 8 in. (20 cm) cable ties, two 4 in. (10 cm) cable ties, and one buzzer and/or one light. Additional tools and supplies you need include a cordless drill, one 3/8 in.…

Add-On: GPSI-4000 Temperature Sensor

The installation kit contains the temperature sensor, one p-clamp, two heat-shrink butt connectors, two standard butt connectors, two grommets, eight 8-in. (20 cm) cable ties with screw holes, twelve 8-in. (20 cm) cable ties, nine self-tapping screws, and one 18-ft. cable extension. Additional tools and parts you may need include electrical tape, insulated wire crimper,…

GPSI-4000LD

The installation kit contains a registration card, the 4000LD device, one external antenna, one 4-pin power harness, one 22-pin expansion harness, one vPOD cable, one OBD-II Pass-Thru Cable, one L-shaped OBD-II bracket, eight 8-in. (20 cm.) zip ties, and two 14-in. (35.5 cm.) zip ties. Additional tools you need include a digital multimeter, cordless drill,…

Add-On: GPSI-4000 Inputs

The 4000 device is equipped with four inputs, which can be enabled upon request. To submit a request, contact the Support Team. Additional tools and/or parts that you may need include: razor knife, electrical tape, zip ties, wire crimper, wire stripper, wire cutter, 12V or 24V relay, relay harness, 20ga wire, ground screw, ring terminal,…