Add-On: GPSI-4000 Driver ID

The Driver ID kit contains one reader, two key fobs, one plastic washer, one metal-locking washer, one wiretap connector, four butt connectors, four 8 in. (20 cm) cable ties, two 4 in. (10 cm) cable ties, and one buzzer and/or one light. Additional tools and supplies you need include a cordless drill, one 3/8 in.…

Add-On: GPSI-4000 Temperature Sensor

The installation kit contains the temperature sensor, one p-clamp, two heat-shrink butt connectors, two standard butt connectors, two grommets, eight 8-in. (20 cm) cable ties with screw holes, twelve 8-in. (20 cm) cable ties, nine self-tapping screws, and one 18-ft. cable extension. Additional tools and parts you may need include electrical tape, insulated wire crimper,…

Add-On: GPSI-4000 Inputs

The 4000 device is equipped with four inputs, which can be enabled upon request. To submit a request, contact the Support Team. Additional tools and/or parts that you may need include: razor knife, electrical tape, zip ties, wire crimper, wire stripper, wire cutter, 12V or 24V relay, relay harness, 20ga wire, ground screw, ring terminal,…

HD Pass-Thru Cable Power Reroute Guide

This optional installation procedure is normally not required. Please refer to the primary Installation Guide for complete device installation instructions and then only proceed with these instructions when necessary. This optional installation guide provides instructions how to reroute power to the HD Pass-Thru cable directly from the vehicle battery. These steps are necessary to resolve…

Unit Verification App

With the GPS Insight Unit Verification App (iOS | Android), you no longer have to call in to verify your installation. The application allows you to quickly verify the installation of the GPS device as well as register the device for immediate viewing within the portal. Before You Begin the Verification Process When you have…

Testing for Battery Drain

Although it may be possible for a device’s power draw to exacerbate existing battery conditions (i.e., an old battery or other after-market products causing draw), the device alone should not cause battery draw issues. If you’re unsure, the following steps will help you test draw: Not in Sleep Mode All testing should be completed when…

GPSI-4000

This advanced GPS tracking device supports more features than the GPSI-3900 such as diagnostics and e-logs. (Daughterboard included.) This device requires a three-wire installation and is typically mounted in the dash where it’s not easily accessible.

GPSI-4000HD

Before You Begin The installation kit contains a registration card, the 4000HD device, one external antenna, one 4-pin power harness, one 22-pin expansion harness, one 9 Pin 500k Pass-Thru cable, eight 8-in. (20 cm.) zip ties, and two 14-in. (35.5 cm.) zip ties. Additional tools that you may need include a digital multimeter, cordless drill,…

GPSI-4000HD

This video walks you through the following steps in the installation process: Locate the vehicle’s diagnostic port, and ensure proper voltage. Install the external antenna, and route the cables. Free up existing JPort, and install the HD Pass-Thru Cable. Mount the replacement diagnostic port. Connect the white wire to ignition, and tape off unused power…